Prepare The Area
Before you get started with the BG10 you need to prepare the area. First and foremost you will want to quickly vacuum the area to get rid of any loose dirt, debris, or other items that are on top of the surface of the carpet.
Remove & Fill Tanks
Remove the dirty water tank that sits on top of the clean water tank. Then take the clean water tank to your sink and fill it with warm tap water to the water line indicated on the tank. Then add two capfuls of Bissell Commercial Cleaning solution. Once complete, replace the tanks so that the dirty water tank is properly seated on top of the clean water tank.
Start The Machine
Turn on the machine, recline the handle and press the trigger to start cleaning. Make slow forward and backward passes as you clean your carpet. Then release the trigger and make one slow forward and backward pass over the same area to suction up dirty water. Avoid over saturating and single area.
Refill Tanks As Needed
The flow indicator will stop spinning when it is time to refill the clean water tank. At this point you should empty the dirty water tank and replace the water and cleaning solution in the clean water tank following the same steps from earlier. When you finish cleaning, make sure to empty and rinse out both the clean and dirty water containers. Make sure to check the brush roll as well.